Microframe Corporation 3007 Series Betriebsanweisung PDF herunterladen (Seite 79)

1-71

1 to 199

33: The MicroKernel cannot unload

In the DOS environment, The MicroKernel returns this status code

for the following reasons:

 You attempted to unload the MicroKernel when you have loaded

another terminate and stay resident (TSR) program after you

loaded the MicroKernel. Unload the other TSR before unloading

the MicroKernel.

 You attempted to unload the MicroKernel from a 32-bit

application that uses the BSTUB interface with the DOS/4G

extender.

34: The specified extension name is invalid

This status code is obsolete in MicroKernel versions 6.0 and later.

An application specified an invalid filename for the extended

partition. Check the validity of the filename.

35: The application encountered a directory error

Either a Get Directory operation specified a drive that does not exist,

or a Set Directory operation specified an invalid pathname. Check

the validity of both the drive and the pathname.

37: Another transaction is active

The application issued a Begin Transaction (19 or 1019) operation

while another transaction was active by the same user or task; the

active transaction can be nested or non-nested. This status code

often indicates a problem in nested transactions within your

application.

38: The MicroKernel encountered a transaction control

file I/O error

This status code is obsolete in MicroKernel versions 7.0 and later.

The MicroKernel tried to write to the transaction control file.

Possible causes for receiving this status code are that the disk is full,

the disk is write protected, the transaction control file

(BTRIEVE.TRN) that is created when you load the MicroKernel has

been deleted, or the transaction control file is flagged read-only or is

corrupt.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 251 252

Keine Kommentare

Microframe Corporation 3007 Series Betriebsanweisung Seite 79